E6582062
4-29 4. [Basic operation] Operation methods of motor
3
4
9
7 Switch to [Setting mode].
Select "4. Basic parameter" and press the [OK]
key. The basic parameter screen is displayed.
8 Select <CMOd: Run command select> and press
the [OK] key.
You can also select <CMOd: Run command
select> on the [Easy mode] screen.
The setting screen is displayed.
9 Select "0: Terminal" and press the [OK] key.
The basic parameter screen is displayed.
Check that the setting value of <CMOd: Run
command select> is "0."
10 Select <FMOd: Frequency command select 1> and
press the [OK] key.
The setting screen is displayed.
1. History function
2. Direct access
3. Guidance function
4. Basic parameters
5. Extended parameters(F - - -)
Top
0.0HzSTOP
15:13
Monitor
Setting Mode
0.0HzSTOP
15:51
Basic parameters
CMOd : Run command select
FMOd : Frequency command select 1
vb : Manual torque boost 1
vL : Base frequency 1
1
10
4.80%
60.0Hz
Pt : V/f Pattern 0
2: Embedded Ethernet
3: RS485 com (connector 1)
4: RS485 com (connector 2)
5: Communication option
0.0HzSTOP
15:51
CMOd :Run command select
1: Operation panel,Ext panel
1: Operation panel,Ext panel
2: Embedded Ethernet
3: RS485 com (connector 1)
4: RS485 com (connector 2)
0.0HzSTOP
15:51
CMOd :Run command select
0: Terminal
F R
0.0HzSTOP
15:52
Basic parameters
CMOd : Run command select
FMOd : Frequency command select 1
vb : Manual torque boost 1
vL : Base frequency 1
0
10
4.80%
60.0Hz
Pt : V/f Pattern 0
F R
To Next Page
Loading...
