E6582062
2-31 2. Installation and wiring
2
3
9
10
■ Connection of control circuit
• The input/output of the control circuit consist of digital input x 8 points, analog input x 3 points,
analog output x 2 points, relay contact output x 3 points, etc. In many cases, the function of input/
output can be switched with parameter setting.
• For the function and electrical specification of each terminal, refer to [2. 3. 5].
• For details of how to operate with terminal input, refer to [4. 4].
For an example of wiring of the control circuit, refer to the "■Standard connection diagram".
■ Standard connection diagram
This diagram shows a standard wiring of the power circuit and control circuit.
Memo
• For the layout and shape of power terminal block of each frame size, refer to [2. 3. 3].
• The cable clamp exists only in frame size A1 to A5.
• Covers to be removed at the time of wiring vary depending on the frame size. For details, refer
to [2. 2].
To Next Page
Loading...
