Toshiba TOSVERT VF-AS3 User Manual

5-1 5. [Fundamental operation] How to use parameters
I
II
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Frequently set parameters include default 10 parameters in [Easy mode] and basic parameters.
This chapter describes these parameters.
This section describes how to select run and frequency commands required for operating the motor, how
to limit the output frequency, how to set acceleration/deceleration time, how to set the electronic thermal
for motor protection, and how to adjust the meter.
5. 2. 1 Selecting how to input run and frequency
commands
(1) Selecting how to input run/stop
<CMOd: Run command select>
■ Function
Select where to input a run command to the inverter.
■ Parameter setting
5
[Fundamental operation]
How to use parameters
5. 1 Table of parameter access
5. 2 Settings of main parameters
Title Parameter name Adjustment range
Default
setting
CMOd Run command select 0: Terminal
1: Operation panel, Extension panel
2: Embedded Ethernet
3: RS485 communication (connector 1)
4: RS485 communication (connector 2)
5: Communication option
0
0: Terminal
1: Operation panel,Ext panel
2: Embedded Ethernet
3: RS485 com (connector 1)
4: RS485 com (connector 2)
0.0HzSTOP
15:06
CMOd :Run command select
Basic parameter Easy mode

Toshiba TOSVERT VF-AS3 Specifications

General

Model	TOSVERT VF-AS3
Category	Inverter
Overload Capacity	150% for 60 seconds
Cooling Method	Forced Air Cooling
Control Method	V/f control, Sensorless vector control
Braking Unit	Built-in
Communication Protocols	Modbus RTU, DeviceNet, Profibus DP
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheat, Ground Fault
Enclosure	IP20
Operating Temperature	-10°C to +50°C
Humidity	5-95% (non-condensing)
Altitude	Up to 1000m