3-1 3. [Basic operation] Operation panel and screen display
I
II
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
This chapter introduces the functions of the operation keys on the operation panel and screen display
and explains how to operate them.
The operation panel allows you to set parameters and monitor the status. This section explains how to
operate the operation panel and how to switch four types of display modes.
3. 1. 1 LCD screen and operation keys
• LCD screen
This screen displays [Standard mode], [Setting mode], [Monitor mode], and [Easy mode] according to
the purpose. When an error occurs, an alarm, trip, etc. are displayed. For details, refer to [3. 1. 2].
Normally, the backlight color is white, but it turns red when a trip occurs. You can adjust the contrast
and set screen settings such as automatic off time. For details, refer to [3. 1. 3].
• [F1] - [F4] keys
They are keys to execute functions displayed on the screen.
For details, refer to [â– [F1] - [F4] keys] described later in this subsection.
3
[Basic operation]
Operation panel and screen display
Memo
• The specifications and operation procedure of the operation panel are common to all the types
of this inverter.
3. 1 Basic of operation panel
[FWD/REV] key
[ i ] key
[STOP/RESET] key
[OK] key
LCD screen
[F1] - [F4] keys
[ESC] key
[HAND/AUTO] key
[RUN] key
Touch wheel
To Next Page
Loading...
Need help?
General