Toshiba TOSVERT VF-AS3 User Manual

E6582062
5. [Fundamental operation] How to use parameters 5-34
4
5
9
This section describes basic parameters not included in [5.2].
Set any parameter in the [Setting mode].
5. 3. 1 Setting energy savings
<AUE: Eco-standby power setting>
■ Function
Turn off the unused function to reduce standby electricity.
■ Parameter setting
Note) The setting value becomes 0 after execution, but a check mark is added to the previous setting
value.
■ Selecting a setting value
1: Embedded Ethernet OFF
Standby electricity can be reduced when you do not use the embedded Ethernet.
5. 3 Setting other basic parameters
Title Parameter name Adjustment range
Default
setting
AUE Eco-standby power
setting
0: -
1: Embedded Ethernet OFF
0
0.0HzSTOP
15:22
AUE : Eco-standby power setting
0: -
1: Embedded Ethernet OFF
Basic parameter

Toshiba TOSVERT VF-AS3 Specifications

General

Model	TOSVERT VF-AS3
Category	Inverter
Overload Capacity	150% for 60 seconds
Cooling Method	Forced Air Cooling
Control Method	V/f control, Sensorless vector control
Braking Unit	Built-in
Communication Protocols	Modbus RTU, DeviceNet, Profibus DP
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheat, Ground Fault
Enclosure	IP20
Operating Temperature	-10°C to +50°C
Humidity	5-95% (non-condensing)
Altitude	Up to 1000m