E6582062
5-33 5. [Fundamental operation] How to use parameters
3
4
5
9
When you select the setting and press the [OK] key, nothing appears momentarily, the same content
displayed at power on appears, and the mode enters [Standard mode].
7: Store user settings
Store the setting values of all current parameters.
8: Rewrite user settings
Rewrite the setting values of the parameters stored in "7: Store user settings" to the inverter.
You can use parameter initial settings specific for users with "7: Store user settings" and "8: Rewrite
user settings."
9: Clear cumulative fan run time
Clear cumulative fan run time to 0.
Set it, for example, when you have replaced the cooling fan.
When you select the setting and press the [OK] key, nothing appears momentarily, the same content
displayed at power on appears, and the mode enters [Standard mode].
12: Clear number of starting
Clear the values on the monitor to 0 for the number of starting, the number of forward starting, and
the number of reverse starting.
When you select the setting and press the [OK] key, nothing appears momentarily, the same content
displayed at power on appears, and the mode enters [Standard mode].
13: Default setting 2 (complete initialization)
Return all parameters to their default settings at a time.
When you select the setting and press the [OK] key, "Init" blinks in the main area and "Initializing"
appears under it for a while.
They disappear momentarily, the same content displayed at power on appears, and the mode
enters [Standard mode].
All parameters are returned to their default settings, and the history data of past trips is also cleared.
Memo
• Set <tyP: Default setting> after stopping the inverter. You cannot set it during run.
CopyScreen
0.0HzSTOP
15:20
Standard mode
lnit
Easy
Initializing...
Monitor
To Next Page
Loading...
Need help?
General
