E6582062
2. Installation and wiring 2-62
2
9
4 Remove four screws of the top cover (mesh) of the DC
reactor.
Store the removed screws so as not to be lost.
5 Remove the top cover (mesh) from the DC reactor.
6 Check the positions of four mounting holes on the back side
of the DC reactor and mount the DC reactor to the panel.
7 Wire the DC reactor and the terminals [PA/+] and [PO] of the
power terminal block.
Connect two wires (with a crimp-style terminal) from each of
two DC reactor units to [PA/+] and [PO].
Connect two flat braided wires for grounding to the ground-
ing terminals respectively.
8 Mount the top cover (mesh) to the DC reactor and tighten
four screws.
Top cover
Screw
DC reactor
mounting
holes
To Next Page
Loading...
