E6581158
F-43
6
, If H is set to "" or "", the output voltage will change in proportion to the input voltage.
, Even if the base frequency voltage (XNX parameter ) is set above the input voltage, the output voltage
will not exceed the input voltage.
, The rate of voltage to frequency can be adjusted according to the rated motor capacity. For example,
setting H to "" or "" prevents the output voltage from increasing, even if the input voltage
changes when operation frequency exceeds the base frequency.
, When the V/F control mode selection parameter (RV) is set to any number between and , the supply
voltage is corrected regardless of the setting of H.
[0: Supply voltage uncorrected, output voltage limited] [1: Supply voltage corrected, output voltage limited]
Output voltage
[᳐]
Input voltage
Output frequency
XN
Hi
h
Low
0
×Input voltage
XNX
Rated voltage
1 the output voltage can be prevented
from exceeding the input voltage.
XNX
Rated voltage
* The above applies when V/F control mode selection
parameter
RV
is set to
"0" or "1".
[2: Supply voltage uncorrected, output voltage unlimited] [3: Supply voltage corrected, output voltage unlimited]
Output voltage
[
᳐
]
Input voltage
Output frequency
XN
High
Low
0
×Input voltage
XNX
Rated voltage
1 the output voltage can be prevented from
exceeding the input voltage.
XNX
Rated voltage
* The above applies when V/F control mode selection
parameter
RV
is set to
"0" or "1".
XNX
Output voltage
[
᳐
]
Output frequency
XN
0
Input voltage
High
Low
XNX
Output voltage
[V]
Output frequency
XN
0
Input voltage
High
Low
* Even if XNX is set for an output voltage lower than the input
voltage, the output voltage will exceed the voltage adjusted
by XNX when the output frequency is higher than the base
frequency 1 XN.