E6581158
B-3
2
2.2 Standard connections
Danger
Prohibited
• Do not connect input power to the output (motor side) terminals (U/T1, V/T2, W/T3).
Connecting input power to the output could destroy the inverter or cause a fire.
• Do not insert a resistor between DC terminals (between PA/+ and PC/-, or between PO and PC/-).
It could cause a fire.
See 6.13.4 for the connection of a resistor.
• First shut off input power and wait at least 10 minutes before touching wires on equipment (MCCB) that
is connected to inverter power side.
Touching the wires before that time could result in electric shock.
Be Grounded
• Securely connect to ground with a ground wire.
It could lead to electric shock or fire when a malfunction or current leak occurs.
To Next Page
Loading...
