E6581158
H-5
8
Note 1: Press the or key to change items displayed in the status monitor mode.
Note 2: You can switch between % and A (ampere)/V (volt), using the parameter H (current/voltage unit
selection).
Note 3: The input (DC) voltage displayed is 1
2
times as large as the rectified d.c. input voltage.
Note 4: The number of bars displayed varies depending on the setting of H (analog input/logic input func-
tion selection). The bar representing VIA or VIB is displayed only when the logic input function is as-
signed to the VIA or VIB terminal, respectively.
If H = : Neither the bar representing VIA nor the bar representing VIB is displayed.
If H = or : The bar representing VIA is not displayed.
The bar representing VIB is displayed.
If H = or : Both the bar representing VIA and VIB are displayed.
Note 5: The number of bars displayed varies depending on the setting of H (logic output/pulse train output
selection). The bar representing the OUT-NO terminal is displayed only when logic output function is as-
signed to it.
If H = : The bar representing OUT-NO is displayed.
If H = : The bar representing OUT-NO is not displayed.
Note 6: The integrated amounts of input and output power will be reset to zero, if you press and hold down the
key for 3 seconds or more when power is off or when the input terminal function CKWH (input
terminal function: 51) is turned on or displayed.
Note 7: If there is no trip record, PGTT is displayed.
Note 9: The cumulative operation time increments only when the machine is in operation.
To Next Page
Loading...
