E6581158
C-3
3
3.1.1 How to start and stop
[Example of a EOQF setting procedure]
Key operated LED display Operation
Displays the operation frequency (operation stopped).
(When standard monitor display selection H=ҏ [Operation
frequency])
CWJ
Displays the first basic parameter [History (CWJ)].
EOQF
Press either the or key to select “EOQF”.
Press ENTER key to display the parameter setting. (Default setting:).
Change the parameter to (terminal board) by pressing the key.
⇔EOQF
Press the ENTER key to save the changed parameter. EOQF and the
parameter set value are displayed alternately.
(1) Start and stop using the operation panel keys (EOQF=)
Use the and keys on the operation panel to start and stop the motor.
: Motor starts.
: Motor stops.
(2) RUN/STOP by means of an external signal to the terminal board (EOQF=):
Sink logic
Use external signals to the inverter terminal board to start and stop the motor.
Frequency
ON
OFF
F-CC
Slow down and
stop
* Coast stop
The standard default setting is for slowdown
stop. To make a coast stop, assign a "1(ST)"
terminal function to an idle terminal using the
programmable terminal function.
Change toH=.
For coast stop, open the ST-CC when stopping
the motor in the state described at left.The
monitor on the inverter at this time will display
QHH.
Motor
speed
ON
OFF
ON
OFF
F-CC
ST-CC
Coast stop
᳀
᳀᳀
᳀
Short and terminals: run forward
Open and terminals: slow down
and stop
CC
F CC
MODE
To Next Page
Loading...
