E6581158
D-2
4
Panel jog mode
: This mode allows you to jog the motor by controlling the
operation from the operation panel.
This mode is hidden by default.
To use the panel jog mode, set the parameter H to.
Here is the sequence in which modes change each time you press the key.
Standard monitor
mode
Status monitor
mode
Setting monitor
mode
MODE
MODE
Panel jog mode
MODE MODE
Note: When the inverter is in operation (RUN lamp is blinking) or when an operation command is issued (RUN lamp is lit),
the inverter cannot be switched to panel jog mode.
MODE
To Next Page
Loading...
