Trackmaster TMX428 - Tmx428 Cp & Tmx58 Parameter Screen; Tmx428 Cp & Tmx58 Stop History

TRACKMASTER Ch. 12 Removal and Replacement of Components
317-160-406 Rev 4 TMX428 TMX428CP & TMX58 Service Manual 125
May 2021
TMX428CP & TMX58 PARAMETER SCREEN
To gain access to the parameter screen hold down on QUICK SPEED for approximately 4
seconds.
Parameter screen description:
 P02 Stop History
 P05 Maximum Speed Setting
 P09 Accurate Speed B (External Sensor)
 P10 Firmware version (Lower Board)
 P14 Accurate Speed A (Motor Controller)
 P15-P20 Elevation Calibration Points
 P22 Run Time
 P30 Calibration Fail Code (0=Calibrated)
 C00 Setting = 1 Quick Speed Enabled
Setting = 3 Quick Speed Disable
 C01 Minimum Start Speed 0.0 to 1.0 MPH
 C02 Maximum Elevation
 SPD Manual Control Speed Any +or- Key
 ELE Manual Control Elevation Any +or- Key
NOTE: Do not alter any parameter values with Consulting the factory. Altering the
parameters may cause the treadmill to malfunction.
TMX428CP & TMX58 STOP HISTORY
To view history highlight the P2 parameter and hold down on the QUICK SPEED 2 for
approximately 5 seconds.
Using the + or – key, this allows you to highlight a specific stop code and receive a breif
description for stopping (Example 34 is NORMAL STOP).
 Start Rejected (8 or 40)
 Stop due to kill switch open (16 or 48)
 Motor Controller Fault (64 or 96)
 Overspeed Motor Controller (128 or 160)
 Overspeed External Speed Sensor (256 or 288)
 Speed Delta Error (512 or 544)
 Set Speed to Zero Command (1024 or 1056)
 Auto Stop Command (2048 or 2080)
 Measured Zero Speed Error (8224)
TMX428 VERSION 0.4C
ENTER: NEXT PROG: PREV +- EDIT START: EXIT
P00
1
P01
400000
P02
33
P03
160
P04
100
P05
150
P06
0
P07
0
P08
0
P09
0
P10
135
P11
1000
P12
25
P13
14925
P14
0
P15
19
P16
96
P17
198
P18
305
P19
400
P20
495
P21
990
P22
11
P23
35
P24
0
P25
160
P26
342
P27
1000
P28
1000
P29
7615
P30
0
P31
0
P32
0
P33
4000
P34
0
P35
5
P36
7
P37
4753
C00
1
C01
0.1
C02
25.0
SPD
0.0
ELE
0.0
STOP HISTORY (00=MOST RECENT)
+- SELECT COOL DOWN:EXIT
#00
34
#01
544
#02
34
#03
34
#04
34
#05
34
#06
34
#07
34
#08
34
#09
34
#10
34
#11
34
#12
34
#13
34
#14
34
#15
34
#16
34
#17
34
#18
34
#19
34
NORMAL STOP
4