TRACKMASTER Ch. 5 Set-up Instructions
317-160-406 Rev 4 TMX428 TMX428CP & TMX58 Service Manual 35
May 2021
Safe Handling Guidelines
Do not attempt to move the treadmill with the handrails in the shipping position due to the
possibility of cutting the internal wiring. You must either fully secure the handrails in their
upright position or secure handrails in the folded position with 3/8-16 bolt.
Lift the end of the bed assembly to a comfortable height, keeping knees bent and back
straight as you lift.
Rotate the treadmill in the direction you want to go (the treadmill will pivot on its wheels)
and push forward.
When you have maneuvered the treadmill into its location, gently lower the end of the bed
assembly to the floor.
WARNING
The device
weight is 425lbs. This requires 2 people to safely remove it from the
pallet and locate it in the facility.
If you are moving the treadmill over rough surface, such as pavement, use a dolly
under front of the treadmill to prevent damage to the wheels and lift mechanism.
Location
Place the treadmill
on a firm and level hard surface that is free of tile grout lines. The illustration
below shows the minimum recommended clearances from the treadmill edges to any obstruction
for dismount and safety purposes. Observe that the operator should be stationed by the E-Stop.
To Next Page
Loading...
