EasyManua.ls Logo

Trackmaster TMX428 - Page 156

Trackmaster TMX428
159 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
154 TMX428 TMX428CP & TMX58 Service Manual 317-160-406 Rev 4
May 2021
Cleaning: Manual
Step 1 Turn the main power switch to OFF and disconnect the treadmill
from its power outlet.
Step 2 Use 20 mL (0.68 oz) of an alkaline cleaner or similar mild, non-
abrasive detergent (ex. Spray 409) on a soft, clean, lint-free 25 x
25 cm (9.8 x 9.8 in) size cloth / paper towel and manually clean
item 1, 2, & 6 (if applicable). Reference Image 1 for corresponding
items. Note: Do not spray cleaning chemical directly on the device
Step 3 Use an appropriately sized soft-bristled brush (e.g. standard
toothbrush) dampened with 5 mL (0.17 oz) of mild soapy tap water
(or similar mild, non-abrasive detergent) to clean item 3 and hard
to reach spots. Reference Image 1 for corresponding items.
Step 4 Wipe all surfaces 1-6 (reference Image 1) with a soft, clean, lint-
free 25 x 25 cm (9.8 x 9.8 in) size cloth / paper towel dampened
with 20 mL (0.68 oz) (not wet) of lukewarm tap water 27°C to
44°C (80°F to 111°F) for a minimum of 30 seconds.
Step 5 Dispose of all cleaning materials according to your institutions
established procedure.
Disinfection
If necessary, to disinfect the treadmill, follow these steps.
Step 1 Turn the main power switch to OFF and disconnect the treadmill
from its power outlet.
Step 2 Prepare 20 mL (0.68 oz) of 70% or greater isopropyl alcohol
disinfectant solution according to the manufacturer’s directions.
Step 3 Use a soft, clean, lint-free 25 x 25 cm (9.8 x 9.8 in) size cloth /
paper towel or gauze that is saturated with 20 mL (0.68 oz) of the
disinfection solution and manually disinfect all contaminated
surfaces of the device for a minimum of 15 minutes.
Step 4 Use an appropriately sized soft-bristled brush (e.g. standard
toothbrush) dampened with 5 mL (0.17 oz) of the disinfectant
solution to clean item 3 and hard to reach spots. (reference Image 1
for corresponding items) Surface must remain wet for a minimum
of 15 minutes.
Step 5 Wipe all contaminated surfaces 1-6 (reference Image 1) with a soft,
clean, lint-free 25 x 25 cm (9.8 x 9.8 in) size cloth / paper towel or
gauze dampened with 20 mL (0.68 oz) of purified water 27°C to
44°C (80°F to 111°F) for a minimum of 30 seconds.
Step 6 Dispose of all cleaning materials according to your institutions
established procedure.
Drying
Dry the device with a soft, clean, lint-free cloth/paper towel 25 x 25 cm (9.8
x 9.8 in).
Maintenance,
Inspection and
Testing
Visually examine each device for cleanliness. If visible soil remains, repeat
cleaning procedure until the device is thoroughly clean.
Packaging
Not applicable
Sterilization
Not applicable

Table of Contents

Related product manuals