8-Printer Commands Epic Edge™ OEM Integration Manual
Page 124 August 2018 100-14444 Rev B
GS h – Set Bar Code Height
Description
Defines the height of the bars (in dots) for bar codes. The height is defined in n/203 inch
increments, corresponding to the height of a single dot. For example, specify 203 as the
value for n to print a 1-inch high bar code. Note that the bar code height is always
rounded up to the next multiple of 8.
The default setting is 100.
Expression
[GS] h <n>
Parameters n = the desired height (in dot lines) of the bar code,
where n/203 represents the height in inches.
To Next Page
Loading...
