6-Printer Operation Epic Edge™ OEM Integration Manual
Page 54 August 2018 100-14444 Rev B
• Start the Epic Printer Update tool on the host
• Select the appropriate serial port on the update tool.
• Point the update tool to the appropriate firmware file and select Download
• During the download the printer LEDs will flash in several different patterns
depending on the state of the update process.
• After the download has been completed, the printer will alternately blink the
Ready and Fault LEDs
• Remove the USB cable
• The printer will reset, initialize the downloaded firmware, and print a self test
ticket for confirmation. If the rare case that the printer does not automatically
reset on removal of the cable, the printer may be manually restarted using the
reset button.
• The printer will then reenable game communications and return to normal
operation.
• If the firmware download was not successful, the printer will remain in the
download mode after the USB cable is removed.
Micro SD Card Update
The Edge printer firmware may also be updated using a micro SD card.
Micro SD Card Update Procedure
• Copy the desired firmware file to a micro SD card and insert it into the receptacle
on the side of the printer. Note: The card must contain only the firmware file to be
loaded into the printer.
• The printer will automatically detect the card, disable game communications, and
read the firmware update file from the card
• During the update the printer LEDs will flash in several different patterns
depending on the state of the update process.
• After the download has been completed, the printer will alternately blink the
Ready and Fault LEDs
• Remove the SD card
• The printer will reset, initialize the downloaded firmware, and print a self test
ticker for confirmation.
• The printer will then reenable game communications and return to normal
operation.
• If the firmware download was not successful, the printer will remain in the
download mode after the SD card is removed.
.
To Next Page
Loading...
