100-14444 Rev B August 2018 Page 65
Line Objects
Line objects are created using the draw line in landscape printing mode command (GS
l).
Line objects may only be printed as part of a landscape page. If the length of a line
object is set to exceed the printable area of a ticket, the line will be truncated at the end
of the printable area.
General Notes
In any mode, the set feed length command (GS L) is used to determine how far the Epic
Edge™ will feed in search of a Black Dot/Top of Form indicator. If the Epic Edge™ finds
a Black Dot/Top of Form indicator before the maximum feed distance is reached, it will
stop at that point, rather than continuing. This command is only needed when dealing
with continuous-feed tickets.
To Next Page
Loading...
