8-Printer Commands Epic Edge™ OEM Integration Manual
Page 76 August 2018 100-14444 Rev B
SO – Set Font to Double-wide
Description
Causes all the text that follows the command on the same line to be printed as double-
wide characters. Double-wide characters are canceled by a line feed (CR or LF) or the
DC4 command.
Double-wide is a character attribute which is available on a character-by-character basis.
Double-wide text can be canceled at any point on the line, and is automatically canceled
at the end of the line. Therefore, subsequent lines will not be printed as double-wide text
unless the SO command is reissued at the beginning of each line.
See also:
DC4 – Cancel Double-wide Mode
Expression
[SO]
0EH
To Next Page
Loading...
