8-Printer Commands Epic Edge™ OEM Integration Manual
Page 132 August 2018 100-14444 Rev B
2 Not Top of Form State Top of Form State
3 (logical) Ticket loaded Ticket not loaded
4 Bar Code not Completed Bar Code Completed
5 Ticket not Completed Ticket Completed
6 Ticket not in path Ticket in path
7 MSB No paper jam Paper Jam
Note 1: This command will reset the Ticket and Bar Code Completed Status bits
Note 2: To reset the Validation and Bar Code Complete status bits, the [ESC]@
command must be issued. In addition, the Validation Complete and the Barcode
Complete are stored in Nonvolatile Memory on the printer and will remain set through a
power failure.
Validation complete is set when the Validation number is printed on the ticket. Per the
Gaming Control Board policy, the validation number must be printed first.
GS~SS – Printer Send Status
Description
The GS~SS command is a status request sent by the host which requests a particular
status record, specified by the StatusID parameter. See the section Programmable
Automatic Periodic Status, earlier in this Appendix, for a definition of the status IDs.
This command can either be used in conjunction with the periodic status, or with periodic
status disabled.
Expression
[GS]~SS <StatusID>
0
To Next Page
Loading...
