8-Printer Commands Epic Edge™ OEM Integration Manual
100-14444 Rev B August 2018 Page 89
ESC F – Select Fonts
Description
The ESC F command selects a font based on the specified point size, width ratio and
attributes.
Expression
1BH 46H <n1><n2><n3>
<27> <70> <n1><n2><n3>
Parameters n1 = Point size of font
n2 = Font width ratio. This parameter is
currently reserved for future use, but must
have a value specified.
n3 = Attributes, where n3=1 selects
double strike, and values with the most
significant bit (MSB) set to 1 will select
fixed pitch fonts.
To Next Page
Loading...
