6-Printer Operation Epic Edge™ OEM Integration Manual
100-14444 Rev B August 2018 Page 47
Installing the 120mm Ticket Adapter
The Epic Edge™ printer can be configured to use 65mm x 120mm ticket stock by
installing the short ticket adapter. This adapter is provided with the printer and stored in
a pocket in the paper bucket. To install the adapter remove the screw holding the
adapter in the storage slot, remove the adapter, and position it as shown in the picture
below. Install the screw to retain the adapter.
Note: The EGM application software must be configured for the 120mm ticket length for
the printer to operate correctly
Remove screw
and adapter
Install screw and
adapter
To Next Page
Loading...
