TransAct Epic Edge - GS T - Set Characters Per Line in Landscape

8-Printer Commands Epic Edge™ OEM Integration Manual
100-14444 Rev B August 2018 Page 127
GS t – Set Characters per Line in Landscape
Description
Creates an internal memory buffer to store landscape text and bar codes until a form
feed is received. The size of the buffer is determined by n, the number of characters per
line.
The n parameter is converted internally to millimeters, so new line lengths can be
automatically calculated in the event a font change takes place. The conversion to
millimeters is performed by multiplying the value of n by the width of whatever font is
currently set when the GS t command is sent.
This command may be used in conjunction with the GS T command to determine where,
if at all, text wraps to the next line.
This command is similar to the GS u command.
See also
GS u – Set Characters per Line in Portrait
GS T – Select Line Wrap/Truncate Modes
Expression
ASCII
[GS]
t <
n
>
Hexadecimal
1DH 74H <
n
>
Decimal
<29> <116> <n>
Parameters n = the desired number of characters per line in
landscape mode