TransAct Epic Edge - Page 168

9-Transact Template Language Epic Edge™ OEM Integration Manual
Page 158 August 2018 100-14444 Rev B
ASCII
[GS] Q
n
Hexadecimal
1DH 51H n
Decimal
<29> <81> n
Parameters
n = the definition to query, in the range 1 ≤ n ≤ 255.
Notes
Each definition requires two extra bytes for overhead, which are transparent to the user
(i.e., they are not executed). Therefore, if region/template definition n contains 4 bytes,
the GS Q command will return <0><6>
GS O – Execute Region/Template
Description
This command executes a template/region. The data format for this command depends
on whether a template or region is referenced by parameter n. When this command is
received the command sequence stored in the region/template definition is executed as
if it is being received from the host.
Expression
ASCII
[GS] O
n
Hexadecimal
1DH 4FH
n
Decimal
<29> <79>
n
Parameters
n
= the template or region to execute, in the range 1
≤
n
≤ 255.
If the command references a region, any data required for that region must immediately
follow the command. Once all desired regions have been executed, the host must issue
a [FF] command to initiate the ticket print operation.
If the command references a template, the template will be executed immediately using
the data previously loaded using the [GS] C commands.
If the selected template or region is undefined, or if n = 0, no operation is performed.