TransAct Printrex 980 - Page 143

Appendix A: Ordering Genuine Ithaca Supplies
100-11672 - Rev D Page 133
Cause
Procedure
Check Item
Action
8
Replace Transport Unit, and then check
that the defect has been recovered.
End
Printhead
9
Replace Printhead, and then check that
the defect has been recovered.
End
Printer
Controller
PCB
10
Replace Printer Controller PCB, and
then check that the defect has been
recovered.
End
Print Module
11
Replace Print Module, and then check
that the defect has been recovered.
End
Relative Misregistration in Colors in X or Y Direction
Cause
Procedure
Check Item
Action
Registration
Adjustment
1
Carry out registration adjustment, and
then check that the defect has been
recovered.
End
Printhead
2
Printhead Unit is not assembled
properly.
Reassemble it
properly
3
Unit is not installed properly.
Reinstall it
properly
Pinch Roller
Unit or Spur
Unit
4
Unit is not installed properly.
Reinstall it
properly
5
Pinch Roller or Spur does not rotate
smoothly.
Replace Pinch
Roller Unit or
Spur Unit
Transport
Unit
6
Transport Belt is not located at the
correct position.
Move Transport
Belt back to the
correct position.
7
Replace Transport Motor, and then
check that the defect has been
recovered.
End
8
Replace Transport Unit, and then check
that the defect has been recovered.
End
Printhead
9
Replace Printhead, and then check that
the defect has been recovered.
End
Printer
Controller
PCB
10
Replace Printer Controller PCB, and
then check that the defect has been
recovered.
End
Print Module
11
Replace Print Module, and then check
that the defect has been recovered.
End