TransAct Printrex 980 - Page 209

Appendix A: Ordering Genuine Ithaca Supplies
100-11672 - Rev D Page 199
Code
Detail Code
Item
Description
10: Printhead Ink Level Sensor Error
10
01-FF
(Additional
value of
K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value of
K:10,C:20,
M:40,Y:80)
(MODULE2)
Condition
Detected
Ink Upper Limit Sensor detected while Ink
Lower Limit Sensor did not.
Action
1. Replace Printheads.
2. Replace Flexible Cable.
3. Replace Printhead Relay PCB.
4. Replace Printer Controller PCB.
11: Printer Subheater Error
11
01-FF
(Additional
value of
K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value of
K:10,C:20,
M:40,Y:80)
(MODULE2))
Condition
Detected
Specified temperature is not reached even
though Subheater is running
Action
1. Replace Printheads.
2. Replace Flexible Cable.
3. Replace Printhead Relay PCB.
4. Replace Printer Controller PCB.
12: Printhead Connection Error
12
01-FF
(Additional
value of
K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value of
K:10,C:20,
M:40,Y:80)
(MODULE2)
Condition
Detected
Printhead connection error
Action
1. Reattach Printhead.
2. Replace Printheads.
3. Replace Flexible Cable.
4. Replace Printhead Relay PCB.
5. Replace Printer Controller PCB.
13: Printhead Data Error
13
01-FF
(Additional
value of
K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value of
K:10,C:20,
M:40,Y:80)
(MODULE2)
Condition
Detected
Printhead EEPROM data error
Action
1. Replace Printheads.
2. Replace Printer Controller PCB.