TransAct Printrex 980 - Page 213

Appendix A: Ordering Genuine Ithaca Supplies
100-11672 - Rev D Page 203
Code
Detail Code
Item
Description
3. Replace Valve Unit.
29
22
Condition
Detected
Wipe Valve position error
Action
1. Check Wipe Valve Sensor connector
connection.
2. Check Valve Motor connector connection.
3. Replace Wipe Valve Sensor.
4. Replace Valve Motor.
5. Replace Valve Unit.
29
23
Condition
Detected
Wipe Valve position error
Action
1. Check Wipe Valve Sensor connector
connection.
2. Check Valve Motor connector connection.
3. Replace Wipe Valve Sensor.
4. Replace Valve Motor.
5. Replace Valve Unit.
29
7F
Condition
Detected
Wipe Valve position error
Action
1. Check Wipe Valve Sensor connector
connection.
2. Check Valve Motor connector connection.
3. Replace Wipe Valve Sensor.
4. Replace Valve Motor.
5. Replace Valve Unit.
1B: Printhead of the Fuse to Be Blown
1B
01-FF
(Additional
value of
K:01,C:02,
M:04,Y:08)
(MODULE1),
(Additional
value of
K:10,C:20,
M:40,Y:80)
(MODULE2)
Condition
Detected
Printhead of the fuse to be blown
Action
Replace Printer Controller PCB.
F0: Software Error
F0
01
Condition
Detected
ASIC bus access timeout error
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.
3. Save the printer stored data to a file, and
then
report to manufacturer.
F0
02
Condition
Detected
Command with invalid parameters sent to print
processing Unit
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.