TransAct Printrex 980 - Page 215

Appendix A: Ordering Genuine Ithaca Supplies
100-11672 - Rev D Page 205
Code
Detail Code
Item
Description
then
report to manufacturer.
F0
0A
Condition
Detected
Invalid delay occurring during print processing
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.
3. Save the printer stored data to a file, and
then
report to manufacturer.
F0
0B
Condition
Detected
Temperature control processing activated when
Printhead temperature acquisition processing
was not at work.
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.
3. Save the printer stored data to a file, and
then
report to manufacturer.
F0
0C
Condition
Detected
Resumption of printing from invalid address
attempted.
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.
3. Save the printer stored data to a file, and
then
report to manufacturer.
F0
0D
Condition
Detected
Motor drive command issued to motor driver
during motor drive.
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.
3. Save the printer stored data to a file, and
then
report to manufacturer.
F0
0E
Condition
Detected
Printing started while all Printheads were
masked.
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.
3. Save the printer stored data to a file, and
then
report to manufacturer.
F0
0F
Condition
Detected
Stepping motor drive parameter error
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.
3. Save the printer stored data to a file, and
then
report to manufacturer.
F0
10
Condition
Detected
Buffer Valve Solenoid has been energized for
longer than specified
Action
1. Turn off Printer, and then turn on Printer
2. Update the firmware.
3. Save the printer stored data to a file, and