TSC TDP-247 Programming Manual

TSC AUTO ID Technology Co., Ltd. III Copyright 2013 All Rights Reserved.
GOSUB…RETURN.............................................................................................................................. 139
GOTO ................................................................................................................................................ 140
INP$( ) .............................................................................................................................................. 141
INP( ) ................................................................................................................................................ 142
LOB( ) ................................................................................................................................................ 143
INPUT ............................................................................................................................................... 144
PREINPUT ......................................................................................................................................... 145
POSTINPUT ....................................................................................................................................... 146
SET FILTER ON/OFF ........................................................................................................................... 147
REM .................................................................................................................................................. 148
OUT .................................................................................................................................................. 149
OUTR ................................................................................................................................................ 150
GETKEY( ) .......................................................................................................................................... 151
INT( ) ................................................................................................................................................. 152
LEFT$( ) ............................................................................................................................................. 153
LEN( ) ................................................................................................................................................ 154
MID$( ) ............................................................................................................................................. 155
RIGHT$( ) .......................................................................................................................................... 156
STR$( ) .............................................................................................................................................. 157
STRCOMP ( ) ..................................................................................................................................... 158
INSTR ( ) ............................................................................................................................................ 159
TRIM$( ) ............................................................................................................................................ 160
LTRIM$( ) .......................................................................................................................................... 161
RTRIM$( ) ......................................................................................................................................... 162
TEXTPIXEL( ) ..................................................................................................................................... 163
BARCODEPIXEL( ) .............................................................................................................................. 164
VAL( ) ................................................................................................................................................ 165
BEEP ................................................................................................................................................. 166
NOW$( ) ........................................................................................................................................... 167
NOW................................................................................................................................................. 168
FORMAT$( ) ...................................................................................................................................... 169
DATEADD() ....................................................................................................................................... 171
Device Reconfiguration Commands ..................................................................................................... 173
SET COUNTER ................................................................................................................................... 173
SET CUTTER ...................................................................................................................................... 174
SET PARTIAL_CUTTER ....................................................................................................................... 175
SET BACK .......................................................................................................................................... 177
SET KEY1, SET KEY2, SET KEY3 ........................................................................................................... 179
SET LED1, SET LED2, SET LED3 .......................................................................................................... 181
SET PEEL ........................................................................................................................................... 183
SET TEAR & SET STRIPER ................................................................................................................... 184
SET GAP ............................................................................................................................................ 186
SET BLINE ......................................................................................................................................... 188
SET HEAD .......................................................................................................................................... 189
SET RIBBON ...................................................................................................................................... 190
SET ENCODER ................................................................................................................................... 191
SET RIBBONEND ............................................................................................................................... 192
SET COM1 ......................................................................................................................................... 193
SET PRINTKEY ................................................................................................................................... 194
SET REPRINT ..................................................................................................................................... 196
SET FEED_LEN .................................................................................................................................. 197
GETSENSOR() ................................................................................................................................... 198
GETSETTING$() ................................................................................................................................. 200
SET USBHOST KEYBOARD/SCANNER ................................................................................................ 203
SET AUTORUN .................................................................................................................................. 204
PEEL .................................................................................................................................................. 205

TSC TDP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Communication Interface	USB 2.0, RS-232
Power Supply	100-240V AC, 50/60 Hz
Operating Temperature	41°F - 104°F (5°C - 40°C)
Operating Humidity	85% non-condensing
Max. Print Width	4.09" (104 mm)
Label Width	1.18" - 4.33" (30 mm - 110 mm)
Storage Temperature	-40 ~ 60°C (-40 ~ 140°F)