Unipulse f395 - Shift; 14-4-2-1.Shift Procedures

14.Waveform Editing
89
14-4-2. Shift
Specify part of the waveform to shift it up/down. There are two screens: one for setting
the range, and the other for setting the amount of shift.
1. Range OK key - - - - - - - - - Determines the range of the waveform.
2. Shift OK key - - - - - - - - - - Determines the shift to make a change to the waveform.
3. Digit select key - - - - - - - - - Selects the digit to input a numerical value. ‘_’ indicates
the selected digit.
4. +/- key- - - - - - - - - - - - - - - Increases/decreases the value of the selected digit.
5. Clear key - - - - - - - - - - - - - Resets the numerical value back to zero.
6. Reading display - - - - - - - - Displays the cursor reading.
7. Simple numerical input - - - Input a numerical value.
Displays the present increment/decrement value in the
numerical display area.
14-4-2-1. Shift Procedures
1. First, sandwich the shifting range with the right and left cursors, and press the
key.
2. The shifting range is determined.
① ②
⑥⑦
④
⑤
③