Unipulse f395 - Unit Setting Method

3.Screen Configuration and Setting Methods
18
3. The basic setting screen in code setting appears. Select "Basic".
4. The judgment setting screen appears. Press and select the setting item
("DPM Hold HI" in this case).
3-3-2. Unit Setting Method
In this manual, the method of setting an item with multiple selections is described as
follows:
Example: Setting a "unit"
This operation can be performed by the following procedures.
1. Press on the main screen.
Code Setting
Page 1 Page 2
MODE → CAL. → PAGE → Unit
CH1
CH2
Main