18-4-9. Reading Indicated Values / Status
Host
F395
ＲＡ
ＲＡ± ００．００
F395
ＲＢ
ＲＢ± ００．００
F395
ＲＣ
ＲＣ ０００００
ＳＰ
Not used
Alarm
0: Normal
1: ADC+OVER
2: ADC-OVER
3: +OVER+
4: -OVER-
Alarm:
High Limit exceeded:
Low Limit exceeded:
・
The X-axis reading (RB ~ ) can be used only in the Waveform and
Displacement Comparison / Hysteresis / Hysteresis 2 mode. In other
modes, indeterminate values are read.
・
The flag "Latest sampled waveform update" of the RC command is
cleared when the RC command is read.
Host
Host
Terminator
Terminator
Terminator
Terminator
Terminator
Terminator
Y-axis reading
Status reading
X-axis reading
High Limit exceeded
0: High Limit or less
1: High Limit exceeded
2: HI-HI Limit exceeded
Reserved Latest sampled
waveform update
0: OFF
1: ON
Low Limit exceeded
0: Low Limit or less
1: Low Limit exceeded
2: LO-LO Limit exceeded
The status priority is as follows:
(HI-HI Limit exceeded) > (High Limit exceeded ) > (High Limit or less)
(LO-LO Limit exceeded) > (Low Limit exceeded) > (Low Limit or more)
(ADC+OVER) > (ADC-OVER) > (+OVER+) > (-OVER-) > Normal
F395
ＲＤ
ＲＤ ．００００
ＳＰ
Host
Terminator
Terminator
Resolution of X-axis reading (The size to one data of the X-axis is read.)
About the Reading Value
・In the Multi-Hold / Waveform
Comparison mode (X-axis is time.
)
Sampling rate Reading value
100Hz 0010. (ms)
200Hz 0005. (ms)
500Hz 0002. (ms)
1kHz 0001. (ms)
2kHz 000.5 (ms)
4kHz 00.25 (ms)
・In the Hysteresis / Waveform and
Displacement Comparison / Hysteresis 2
mode (X-axis is displacement.)
The displayed value
on the item of actual
load calibration
Reading value
(The decimal point
is arbitrary)
0 ～ 2047
1
2048 ～ 4095
2
4096 ～ 8191
4
8192 ～ 9999
8
To Next Page
Loading...