7.Measurement Operation Functional Settings
40
7. Measurement Operation Functional Settings
7-1. Operation Mode
Set the Operation Mode according to the working conditions from the following.
Setting item: Multi-Hold / Wave Comp. / Hysteresis / Wave&Displace / Hysteresis2
When the mode is changed to Hysteresis / Waveform and Displacement Comparison /
Hysteresis 2, if the sampling rate has been set at 4kHz, the sampling rate is automatically
changed to 2kHz. At the same time, the buzzer beeps.
7-2. Sampling Rate
Select the sensor signal reading speed from the following.
Setting item: 4 kHz / 2 kHz / 1 kHz / 500 Hz / 200 Hz / 100 Hz
(4kHz cannot be set in the Hysteresis / Waveform and Displacement Comparison /
Hysteresis 2 mode.)
The relationship between the sampling rate (frequency) and reading speed is as follows:
MODE → Operation Mode → Operation Mode
Sampling rate Reading speed
4kHz 4000 times/sec.
2kHz 2000 times/sec.
1kHz 1000 times/sec.
500Hz 500 times/sec.
200Hz 200 times/sec.
100Hz 100 times/sec.
MODE → Operation Mode → Sample Rate
To Next Page
Loading...