4.Methods of Connection
25
4-3. Control Connector Connection
The control connector is a connector to input signals to allow the F395 to function, and
to output control signals from the F395 to external equipment.
The applicable plug is DDK-manufactured 57-30500 (accessory) or an equivalent.
4-3-1. Connector Pin Assignments
4-3-2. Input and Output Signals
Input signals
・Display after measurement:
A measured value at the completion of measurement is held when this signal is ON,
and the holding is cancelled when OFF in the Waveform Comparison / Waveform
and Displacement Comparison mode.
(See "13-9. Display After Measurement" P81.)
[Holding of the value is cancelled when the next sampling starts.]
1*COM 26*COM
2 IN Display after measurement 27 IN D/Z
3 IN Capture start by external signal 28 IN T/H
4 IN Operation by waveform
termination level
29 IN H/M
5 IN Prohibit touch panel 30 IN START
6 IN Displacement hold cancel 31 IN STOP
7 IN Backlight ON 32 IN HOLD1
8 IN Select HH/LL 33 IN HOLD2
9 IN Reset auto code up 34 IN HOLD3
10 * COM 35 * COM
11 IN CODE1 36 IN CODE16
12 IN CODE2 37 IN STROBE
13 IN CODE4 38 IN Select output
14 IN CODE8 39 IN N.C
15 * COM 40 * COM
16 * COM 41 * COM
17 OUT LO1 42 OUT OK displacement 1
18 OUT OK1 43 OUT HI displacement 1
19 OUT HI 1 44 OUT LO displacement 2
20 OUT HH/LL 45 OUT OK displacement 2
21 OUT LO 2 46 OUT HI displacement 2
22 OUT OK 2 47 OUT COMPLETE
23 OUT HI 2 48 OUT WARNING
24 OUT LO displacement 1 49 OUT Hysteresis return
25 * COM 50 * COM
To Next Page
Loading...