1.Outline of the F395
5
1-6. Waveform Comparison /
Waveform and Displacement Comparison Procedures
In the Waveform Comparison / Waveform and Displacement Comparison mode,
waveform variations with time / displacement are sampled, and a High/Low Limit
Comparison is performed based on the sampled waveform.
A sequential comparison can be performed with respect to dynamic waveform
variations.
The procedures for performing a Waveform Comparison / Waveform and Displacement
Comparison are as follows:
1. Check to see if a waveform is displayed in accordance with the waveform drawing
procedures. (See "1-2. Waveform Drawing Procedures" P3.)
2. Carry out Waveform Comparison / Waveform and Displacement Comparison settings.
(See "13-2. Setting and Operating Method" P68.)
3. Select the channel number(s) you want to control externally.
(See "4-3. Control Connector Connection" P25.)
4. Provide a load to the strain gauge type sensor (displacement sensor), input START and
other signals, and check to see if operation is performed as set.
1-7. Operation Mode at a Glance
Operation
mode
Usable X-axis Maximum
sampling
rate
Hold
Waveform
comparison
Capability
of return
Time
Sensor
Pulse
Multi-Hold
○××
4kHz 9 points for all types
××
Hysteresis
×○○
2kHz 9 points for all types
×○
Waveform
Comparison
○××
4kHz 1 point for three types
○×
Waveform and
Displacement
Comparison
×○○
2kHz 1 point for three types
○×
Hysteresis 2
×○○
2kHz 3 points for one type
×○
To Next Page
Loading...