14.Waveform Editing
91
14-4-3-1. Area Setting Procedures
1. Move the cursors to sandwich the area.
2. Press the key to register the area.
3. The set area is indicated by a blue line at the top of the screen, and outside the area
becomes gray.
14-4-4. Waveform Save
Waveforms edited under “Waveform Editing” are stored by this operation. Waveforms
saved here are used for pass / fail judgment. Up to 16 paird (ch) of waveforms can be set,
and waveforms to be used are set by external operation ch selection signals.
Setting range: 0 ~ 15
To Next Page
Loading...