4.Methods of Connection
21
4-1-1. Analog Input / Output Connection
4-1-1-1. Analog Input / Output Terminal Pin Assignments
1 FG : Frame ground. Terminal to connect the shield of sensor
connection cabling.
2 ＋ EXC : Terminal to connect a strain gauge type sensor.
3 － SIG : Terminal to connect a strain gauge type sensor or displacement
sensor.
4 － EXC : Terminal to connect a strain gauge type sensor.
5 ＋ SIG : Terminal to connect a strain gauge type sensor or displacement
sensor.
6 V-OUT : Terminal that outputs voltage proportional to sensor input.
The voltage output is approx. 2V per 1mV/V sensor input, and
the load resistance is 5kΩ or more
7 N.C
* 1 ~ 6 are input / output terminals for CH1.
8 V-OUT : Terminal that outputs voltage proportional to sensor input.
The voltage output is approx. 2V per 1mV/V sensor input, and
the load resistance is 5kΩ or more.
9 GND : GND terminal for the V-OUT terminal. (Common to pin 6 and
pin 8.)
10 ＋ EXC : Terminal to connect a strain gauge type sensor.
11 － SIG : Terminal to connect a strain gauge type sensor or displacement
sensor.
12 － EXC : Terminal to connect a strain gauge type sensor.
13 ＋ SIG : Terminal to connect a strain gauge type sensor or displacement
sensor.
14 FG : Frame ground. Terminal to connect the shield of sensor
connection cabling.
* 8 ~ 14 are input / output terminals for CH2. (Pin 9 is common to CH1 and CH2.)
The CH1 and CH2 input sensor specifications (strain gauge/current/
voltage) are factory-shipped settings. For changing the settings,
contact us since modifications are required. CH1 corresponds to a
strain gauge, and CH2 corresponds to voltage as a standard.
Request
To Next Page
Loading...