14.Waveform Editing
84
14-4. Waveform Editing
Confirm or edit a waveform on this screen. The waveform can be edited by area setting,
tie drawing, and shifting, and the waveform can be registered by waveform save. Also,
the waveform can be confirmed by scrolling, scaling up/down, and moving the cursor.
1. Area setting key - - - - - - - - - Goes to the area setting screen.
(See "14-4-3. Area Setting" P90.)
2. Tie drawing key - - - - - - - - - Goes to the tie drawing screen.
(See "14-4-1. Tie Drawing" P86.)
3. Shift key - - - - - - - - - - - - - - Goes to the shift screen.
(See "14-4-2. Shift" P89.)
・When two or more samplings are performed, the upper limit
and lower limit of the waveforms obtained by sampling are
registered as the high limit and low limit, respectively.
・ When waveform sampling is executed, OK is output as a
judgment result without performing judgment operation (when
"SAMP" is displayed).
Example: 4th samplings
Red line: High limit waveform
Red line: Low limit
1st time
3rd time
2nd time
Blue line: Latest sampling waveform
(4th time)
To Next Page
Loading...