Unipulse f395 - Graph Confirmation

16.Code Setting
121
16-3. Graph Confirmation
Characteristics of set values are displayed as they are easy to understand for smooth
changing of the set values. This function is applicable only to the items the
characteristics of which can be shown on the graph.
Also, the scale of the graph is fixed at the present value.
If no waveform is displayed, check to see if the setting / scale is suitable for
measurements.
・ When any item different from the X-axis in the selected mode is
changed, like changing the Inhibit Timer when the Hysteresis mode is
used, the graphic display does not appear. If graph confirmation is
needed, set after changing the mode temporarily.
・ Items the graphic display of which is determined by the Operation
Mode are shown according to the Operation Mode.
- Items to be displayed only in the Multi-Hold / Waveform Comparison
mode:
Hold Detect Time/Minimum Peak and Valley Difference / Peak and
Valley Detection Rate / Peak and Valley Ordinal/Minimum Slope
Detection Value / Slope Detection Interval A / Slope Detection
Interval B / Preliminary Slope Detection Point/Inhibit Timer
-Items to be displayed only in the Hysteresis / Hysteresis 2 / Waveform
and Displacement Comparison mode:
Displacement High Limit / Displacement Low Limit / Displacement
Hold High Limit / Displacement Hold Low Limit / Hysteresis Interval