Unipulse f395 - Auto Code up; Code up Point

16.Code Setting
107
16-2-5. Auto Code Up / Code Up Point
In the Multi-Hold / Hysteresis / Hysteresis 2 mode, if the Auto Code Up is set to "ON",
switching of the operation ch is brought into Auto Code Up mode. By using the Auto
Code Up Mode, the operation ch can automatically be updated during sampling in the
Multi-Hold / Hysteresis mode, and hold is executed by the Auto Code Up timing in the
Hysteresis 2 mode (in exchange for Pulse Hold). Set the operation ch update timing in
the Auto Code Up mode under Code Up Point. For details of the Auto Code Up mode,
see "2. Setting by the auto code up function" in "16-1. Method of Setting the Operation
ch" P100.
Auto Code Up
Setting item: ON / OFF
Code Up Point
Setting range: 0 ~ 9999
Multi-Hold mode:
Setting unit = One-time sampling time
Hysteresis / Hysteresis 2 mode:
Setting unit = Amount of displacement
(relative to the X-axis measured value)
In the Multi-Hold mode
In the Hysteresis / Hysteresis 2 mode
MODE → Code Set → Basic:
Auto Code Up
Code Up Point
MODE → Code Set → Basic: PAGE →
Auto Code Up
Code Up Point
Y
X
Code up point
on operation ch 0
Code up point on
on operation ch 1
Code up point on
on operation ch 2
Operation ch 0 Operation ch 1 Operation ch 2 Operation ch 3