Unipulse f395 - Rejected Waveform Clear; Y-Axis Start Point; Y-Axis Scaling

15.Waveform Reading
97
15-3. Rejected Waveform Clear
The oldest rejected waveform is cleared.
The operation is executed by pressing the key.
15-4. Y-axis Start Point
Set the Y-axis start point (lower end) of the graph.
Setting range: -9999 ~ 9999 (Not including the decimal point.)
15-5. Y-axis Scaling
Set the Y-axis scale of the graph. Select scaling so that the input waveform is properly
displayed.
Setting item: 100% / 50% / 20% / 10% / 5% / 2% / 1%
・ Up to the "2nd Last Wave" are stored in the Hysteresis mode.
・ NG waveforms are automatically updated upon their occurrence.
Therefore, if the displayed waveform is automatically cleared, the
display is changed to the waveform set at that time.
MODE → Read Wave → NG Wave CLR.
MODE → Read Wave → Y StartPoint
Y-axis Start
Point
MODE → Read Wave → Y Scale
Y-axis
scale