Unipulse f395 - X-Axis Start Point; X-Axis Scaling

15.Waveform Reading
98
15-6. X-axis Start Point
Set the X-axis start point of the graph.
Setting range: Changed according to the Operation Mode, Sampling Rate, and Actual
Load Calibration value for the X-axis.
(Not including the decimal point in the following table.)
(Load input value for Equivalent Input Calibration (pulse input
calibration for PUI))
15-7. X-axis Scaling
Set the X-axis scale of the graph. Select scaling so that the input waveform is properly
displayed.
Setting item: 100% / 50% / 20% / 10%
Multi-Hold / Waveform
Comparison mode
Hysteresis / Hysteresis 2 / Waveform
and Displacement Comparison mode
Sampling rate Range Calibration value Range
4kHz
0 ～ 500 1 ～ 2047 0 ～ 2000
2kHz
0 ～ 1000 2048 ～ 4095 0 ～ 4000
1kHz
0 ～ 2000 4096 ～ 8191 0 ～ 8000
500Hz
0 ～ 4000 8192 ～ 16383 0 ～ 16000
200Hz
0 ～ 10000
100Hz
0 ～ 20000
MODE → Read Wave → X StartPoint
X-axis
Start Point
MODE → Read Wave → X Scale
X-axis scale