17.System-related Settings and Operations
127
17. System-related Settings and Operations
17-1. Set Value Protection
By this function, it is prohibited to change set values and calibrated values in order to
prevent them from being changed due to misoperation. The following three patterns can
be set.
Setting item: All Unprotect / CAL. Protect / All Protect
All Unprotect .. Calibration can be performed, and also set values can be changed.
The DZ (Digital Zero) function cannot be used.
CAL. Protect ... Calibration cannot be performed, but set values can be changed.
(For the items applicable to "Calibration", see "24. Setting Items list"
P161.)
The DZ (Digital Zero) function can be used.
All Protect ........ Calibration cannot be performed, and also set values cannot be changed.
The DZ (Digital Zero) function can be used.
17-2. Display Update Rate
Set the display update rate of measured values.
Setting range: 0.1 ~ 9.9
17-3. Backlight
The backlight of the color liquid crystal display (LCD) is automatically turned off by this
function. If the touch panel is not touched within the time (min.) set here, the backlight
of the LCD goes out. For lighting the backlight, touch the touch panel, or the turn on the
backlight ON signal.
(See "4-3-2. Input and Output Signals" P25.)
Setting range: 0 ~ 99
MODE → System → Display Rate
MODE → System → Backlight
To Next Page
Loading...