Unipulse f395 - Display after Measurement

13.Waveform Comparison / Waveform and Displacement Comparison Mode
81
13-9. Display After Measurement
Measurement display upon completion of comparison can be selected by the input
"Display after measurement" from the following.
(See "4-3-2. Input and Output Signals" P25.)
1. Input "Display after measurement" ON: The last value is held.
(The held value is canceled when the next sampling starts.)
2. Input "Display after measurement" OFF: Real-time display.
When the setting is "OFF"
・ The result of the previous judgment is cleared when the START
signal is turned on.
・ No output will also result if sampling starts after the end point.
When the setting is "OFF"
Nothing is output.
Comparison area
The results are maintained.
Input waveform
High limit
Low limit
Start point End point