5.Methods of Calibration
35
5-7. Unit
Set the measuring unit. Select from the following.
Setting item: kg / t / g / N / kN / MN / N・m / Pa / kPa / MPa / bar / N/m
2
/ mm / cm
/ μm / rad / deg / lb / oz / dyne / psig / ftlb / inlb / inoz / ft / in / None
5-8. Increment
Set the minimum value of digital changes.
Setting range: 1 ~ 100 (Not including the decimal point.)
5-9. Decimal Place
Set the decimal place.
Setting item: 0 / 0.0 / 0.00 / 0.000
5-10. Zero Calibration
Set the initial zero point.
1. Bring the sensor into a zero condition (no-load condition).
2. Press OK under Zero Calibration.
3. For error display, see "19. Error Messages" P150.
MODE → CAL. → PAGE → Unit
CH1
CH2
MODE → CAL. → PAGE → Increment
CH1
CH2
MODE → CAL.
CH1
CH2
→ Decimal Place
→ PAGE → Decimal Place
MODE → CAL. → Zero CAL.
CH1
CH2
To Next Page
Loading...