Unipulse f395 - Writing the Effective Area of the Sampled Waveform

18.Interface
143
18-4-6. Writing the Effective Area of the Sampled Waveform
End of the area
Ｗ５４ＳＰ
Host
F395
Return
Host
F395
Return
Start of the area
Ｗ５４ＳＰ
Ｗ５５ＳＰ
Ｗ５５ＳＰ
Terminator
Terminator
Terminator
Terminator
4-digit decimal number
Set the size of the effective
waveform area. (0000 ~ 2047)
Sent (written value)
4-digit decimal number
Set the size of the effective
waveform area. (0000 ~ 2047)
Sent (written value)
・ In the Multi-Hold mode and Hysteresis mode, the operation is
executable only when the set value of W51 is 0 ~ 15 or 92.
・ In the Waveform Comparison mode and Waveform and Displacement
Comparison mode, the operation is executable only when the set
value of W51 is 0 ~ 15, 91 or 92.
Effective waveform area
The F395 divides the sampled waveform into 2048 divisions. For the
size of the effective area, set the start and end of the area.
0・・
2040
・・・2047
B
Ｗ５４ＳＰ ２０４０
Terminator
This is the same as in "14-4-3. Area Setting" P90 in key setting.
A
100
Ｗ５５ＳＰ ０１００
Terminator
A B
Example) Making the area between point and effective on the
above graph