5.Methods of Calibration
37
5-12. Actual Load Calibration
Set the span (gain) point of the sensor.
1. Select the "Actual Load Calibration" item.
2. Set in accordance with the display.
Load?.... Setting range: -9999 ~ -100, 100 ~ 9999 (Not including the decimal point.)
3. For error display, see "19. Error Messages" P150.
MODE → CAL. → Actual CAL.
CH1
CH2
Calibration cannot be performed with the same input value
as zero calibration.
The full scale value of displacement is determined by the value
input for the "Load?" item of Equivalent Input Calibration or Actual
Load Calibration in the Hysteresis / Hysteresis 2 / Waveform and
Displacement Comparison mode. The relationship between the
input value (X-axis calibrated value) and full scale value is as
follows:
Input value
(X-axis calibrated value)
Full scale value
1 ～ 2047
2047
2048 ～ 4095
4096
4096 ～ 8191
8188
8192 ～ 9999
16376
To Next Page
Loading...