15.Waveform Reading
92
15. Waveform Reading
Set the functions relating to the waveform display of the F395.
The Y-axis start point to X-axis scaling can be changed on the waveform reading screen
( key operation). Therefore, it is recommended to adjust each waveform reading
on the waveform reading screen after waveform sampling.
(See "14-4. Waveform Editing" P84.)
15-1. Waveform Reading
Each point of the waveform sampled and displayed by the F395 can be read.
1. Cursor center key - - - - - - - - Moves the screen so that the cursor position comes at
the center of the screen.
* If the cursor is positioned near 0 of the X-axis,
centering will not result. The same goes for the case
where the cursor is positioned near -9999 of the Y-
axis.
* Cursor centering is cancelled by screen move or axis
return operation.
2. Hold skip key - - - - - - - - - - - Moves the cursor alone to the next hold point.
The screen is also moved by pressing the cursor center
key in advance.
3. Hold value key - - - - - - - - - - Goes to the hold point screen.
To Next Page
Loading...