16.Code Setting
101
・In go sampling (in the Multi-Hold mode), the operation ch is incremented by one when:
X-axis value ≧ Code up point
（See "16-2-5. Auto Code Up / Code Up Point" P107.）
and in return sampling, when:
X-axis value ≦ Code up point.
(X-axis value: Sampling time when the Multi-Hold mode is set, and X-axis measured
value when the Hysteresis mode is set.)
・ The operation ch can be updated 8 times at maximum.
・ The operation ch is automatically updated until it is repeated 8 times or the Auto Code
Up corresponding to the changed operation ch is set to "OFF".
・ The operation ch is not updated after it reaches 31ch.
・ In the Auto Code Up mode, changing the operation ch by external input is ineffective.
・ When the Hysteresis mode is set, it functions only when:
X-axis measured value < 10000.
・ After completion of sampling, the operation ch is fixed at the last operation ch. By
turning on the START signal at the next sampling, the Auto Code Up mode is
canceled, and the mode in which the operation ch is changed by external signals is
brought about. (After sampling starts, check the auto code up setting again.)
・ In the Auto Code Up mode, reset operation of each hold by the T/H signal or H/M
signal is ineffective. Therefore, each hold can be executed simply by keeping the T/H
signal or H/M signal ON.
・ The Auto Code Up mode can be cancelled not only by turning on the START signal but
also by turning on the input "Reset Auto Code Up" (See "4-3-2. Input and Output
Signals" P25.) after completion of sampling.
To Next Page
Loading...