16.Code Setting
111
1. Hold value
High/Low Limit Judgments are made with respect to the indicated value. When the
operation ch is switched, the results are accumulated at the Judgment output signal ~ 2
(in the Hysteresis / Hysteresis 2 mode). The following two types of High / Low Limit
setting are used.
Displacement Hold High Limit / Displacement Hold Low Limit
Setting range: 0 ~ 9999 (Not including the decimal point.)
In the Hysteresis / Hysteresis 2 mode
In the Waveform and Displacement Comparison mode
MODE → Code Set → Judgment: PAGE →
DPM Hold HI /
DPM Hold LO
MODE → Code Set → Judgment:
DPM Hold HI /
DPM Hold LO
OFF
ON
OK
Displacement Hold
Low Limit
Displacement Hold
High Limit
Displacement
Displacement
High Limit
Low Limit
Indicated value
Output Logic
Displacement
The displacement hi limit is not turned on due to hold.
Also, the output has no connection with the COMPLETE signal.
To Next Page
Loading...